Lubrication; Greasing And Lubrication; Greasing The Mower Deck And Belt Idlers - Toro Z580-D Z Master 74266 Operator's Manual

Important: Refer to your engine operator's manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.

Lubrication

Greasing and Lubrication

Lubricate the machine when shown on the Check
Service Reference Aid decal (Figure 30). Grease more
frequently when operating conditions are extremely
dusty or sandy.
Grease Type: General-purpose grease.
How to Grease
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
5. Wipe up any excess grease.
Greasing the Front Caster Pivots
Service Interval: Yearly (more often in dirty or dusty
conditions).
1. Remove the dust cap and adjust the caster pivots.
Keep the dust cap off until greasing is done. Refer
to Adjusting the Caster Pivot Bearing in , page .
2. Remove the hex plug. Thread a grease zerk into the
hole.
3. Pump grease into the zerk until it oozes out around
the top bearing.
4. Remove the grease zerk in the hole. Install the hex
plug and cap.
Where to Add Grease
Lubricate the grease fittings as shown on the Check
Service Reference Aid decal (Figure 30).
Where to Add Light Oil or Spray
Lubrication
Service Interval: Every 150 hours
Lubricate the machine in the following areas with spray
type lubricant or light oil.
• Seat switch actuator.
• Brake handle pivot.
• Brake rod bushings.
• Motion control bronze bushings.
Greasing the Mower Deck and
Belt Idlers
Service Interval: Every 25 hours—Grease the mower
deck and spindles.
30
Figure 30