Fuel Selector Valve; Throttle Control; Ignition Switch - Toro Z580-D Z Master 74266 Operator's Manual

1. Safety interlock symbols
2. Hour meter

Throttle Control

The throttle control is variable between Fast and Slow.
Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage the
electric clutch to drive the mower blades with the motion
control levers in the center, un-locked position. Pull the
switch up to engage the blades and release. To disengage
the blades, push the blade control switch (PTO) down.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system and to determine neutral position.

Ignition Switch

This switch is used to start the mower engine and has
three positions: Start, Run and Off.
Glow Plug Light
The glow plug indicator light turns on when the glow
plug button is engaged (Figure 4).
Glow Plug Switch
This switch activates the glow plugs and is indicated by
the glow plug light. Hold down the glow plug switch for
10 seconds prior to starting.
Temperature Light
The temperature light comes on when the engine is over
heating (Figure 4).
Audible Alarm
This machine has an audible alarm that alerts the user
to turn off the engine or engine damage can occur from
Figure 5
3. Battery light
over heating. Refer to Servicing the Cooling System in ,
page .

Fuel Selector Valve

The fuel selector valve is located behind the seat.
Close the fuel selector valve when transporting or
storing mower.
Move the selector valve to the lefthand (LH) or
righthand (RH) position for operation.
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
14