Fuel Selector Valve; Throttle Control; Ignition Switch - Toro Z Master Professional 7000 Series Operator's Manual

With 52in rear discharge mower

Hide thumbs Also See for Z Master Professional 7000 Series:

Operator's manual (364 pages)

Setup instructions (16 pages)

Operator's manual (80 pages)

Table Of Contents

Table of Contents

Battery Indicator Light

When the ignition key is initially turned to the Run position

for a few seconds, the battery voltage will be displayed in the

area where the hours are normally displayed.

The battery light turns on when the ignition is turned on

and when the charge is below the correct operating level

(Figure 5).

1. Safety interlock symbols

2. Hour meter

Throttle Control

The throttle control is variable between Fast and Slow.

Blade Control Switch (PTO)

The blade control switch (PTO) is used to engage the electric

clutch to drive the mower blades with the motion control

levers in the center, un-locked position. Pull the switch up to

engage the blades and release. To disengage the blades, push

the blade control switch (PTO) down.

Neutral Lock Position

The neutral lock position is used with the safety interlock

system and to determine neutral position.

Ignition Switch

This switch is used to start the mower engine and has three

positions: Start, Run and Off.

Glow Plug Light

The glow plug indicator light turns on when the glow plug

button is engaged (Figure 4).

Glow Plug Switch

This switch activates the glow plugs and is indicated by the

glow plug light. Hold down the glow plug switch for 10

seconds prior to starting.

Figure 5

3. Battery light

Temperature Light

The temperature light comes on when the engine is over

heating (Figure 4).

Audible Alarm

This machine has an audible alarm that alerts the user

to turn off the engine or engine damage can occur from

overheating. Refer to Servicing the Cooling System in

Cooling System Maintenance (page 42).