Fuel Selector Valve; Throttle Control; Ignition Switch - Toro 74266 Operator's Manual

The battery light turns on when the ignition is turned on
and when the charge is below the correct operating level
(Figure 6).
1. Safety interlock symbols
2. Hour meter

Throttle Control

The throttle control is variable between Fast and Slow.
Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage the electric
clutch to drive the mower blades with the motion control
levers in the center, un-locked position. Pull the switch up to
engage the blades and release. To disengage the blades, push
the blade control switch (PTO) down.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system and to determine neutral position.

Ignition Switch

This switch is used to start the mower engine and has three
positions: Start, Run, and Off.
Glow Plug Light
The glow plug indicator light turns on when the glow plug
button is engaged (Figure 5).
Glow Plug Switch
This switch activates the glow plugs and is indicated by the
glow plug light. Hold down the glow plug switch for 10
seconds prior to starting.
Temperature Light
The temperature light comes on when the engine is over
heating (Figure 5).
Figure 6
3. Battery light
Audible Alarm
This machine has an audible alarm that alerts the user to turn
off the engine or engine damage can occur from over heating.
Refer to Cooling System Maintenance (page 44).

Fuel Selector Valve

The fuel selector valve is located behind the seat.
Close the fuel selector valve when transporting or storing
mower.
Move the selector valve to the lefthand (LH) or righthand
(RH) position for operation.
Attachments/Accessories
A selection of Toro approved attachments and accessories are
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
15