Hour Meter - Toro 74710 TimeCutter SS 3225 Operator's Manual

to the park position and exit the machine
position the motion-control levers into the park position
when you stop the machine or leave it unattended.
Smart Speed™ Control System Lever
The Smart Speed™ Control-System lever, located below the
operating position, gives the operator a choice to drive the
machine at 3 speed ranges— trim, tow, and mow
1. Smart-speed lever
Fuel-Presence Window
The fuel window located on the left-hand side of the machine,
can be used to verify the presence of gasoline in the tank
(Figure 7).
G014521
1
1. Fuel-presence window
Height-of-Cut Lever
The height-of-cut lever allows the operator to lower and
raise the deck from the seated position. When the lever is
moved up (toward the operator), the deck is raised from the
ground, and when moved down (away from the operator), it
is lowered toward the ground. Only adjust the height-of-cut
while the machine is not moving
(Figure 15). Always
(Figure
Figure 6
Figure 7
(Figure 4).

Hour Meter

The hour meter records the number of hours when the
operator is in the seat and the ignition switch is in the ON
position (Figure 8).
6).
1. Hour meter location behind the seat
13
1
g028019
Figure 8