Servicing The Spark Plug - Toro 74710 TimeCutter SS 3225 Operator's Manual

A
B
C D
F
E
g027477
Figure 33
6. Slowly pour approximately 80% of the specified
amount of oil into the fill hole
7. Check the oil level; refer to
3/4
(Figure 34).
Figure 34.
A
C
E

Servicing the Spark Plug

Service Interval: Every 50 hours—Check the spark plug.
Every 100 hours—Replace the spark plug.
Ensure that the air gap between the center and side electrodes
is correct before installing the spark plug. Use a spark plug
wrench for removing and installing the spark plug and a
gapping tool or feeler gauge to check and adjust the air gap.
Install a new spark plug if necessary.
Type: Champion ® RC12YC, Autolite
BCPR6ES
Air Gap: 0.76 mm (0.03 inch)
Removing the Spark Plug
1. Disengage the blade-control switch (PTO).
2. Stop the engine, wait for all moving parts to stop, and
remove the key before leaving the operating position.
29
B
D
F
g027484
Figure 34
® 3924, or NGK ®