Engine Maintenance; Servicing The Air Cleaner - Toro 74710 TimeCutter SS 3225 Operator's Manual

3. Clean the grease fittings
a rag.
Note: Make sure to scrape any paint off of the front
of the fitting(s).
Figure 26
1. Front caster tire
Figure 27
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance
2. Check the tire pressure
every 25 operating hours
4. Connect a grease gun to each fitting
Figure 27).
5. Pump grease into the fittings until grease begins to
ooze out of the bearings.
(Figure 26 and Figure 27) with
1
G014522
3. Grease every 25 operating
hours
4. Engine
(Figure 26 and

Engine Maintenance

Servicing the Air Cleaner

Service Interval: Before each use or daily—Clean and check
the air cleaner foam element.
Every 50 hours—Replace the air cleaner paper
element.
Note: Service the air cleaner more frequently if the operating
conditions are extremely dusty or sandy.
Removing the Foam and Paper
Elements
1. Disengage the blade-control switch (PTO).
2. Stop the engine, wait for all moving parts to stop, and
remove the key before leaving the operating position.
3. Clean around the air cleaner to prevent dirt from
getting into the engine and causing damage.
4. Remove the air-cleaner cover by unscrewing the 2
knobs (Figure 28).
1. Air-cleaner cover
5. Carefully remove the foam and paper filter elements
from the air-cleaner housing
26
G017862
Figure 28
2. Knobs
(Figure 29).