Canon LBP6780x Manual page 901

printed properly.
Perform the following procedure.
1. Perform a soft reset.
Solution 2
2. After the soft reset, either perform a hard reset or turn the printer back ON, increase memory
capacity and print again. (All data in the memory will be erased.)
Not enough work memory. <Auto Error Skip>
<Cause> The work memory for each print mode cannot be secured.
Press [
printed properly.
Solution 1
When continuing printing by pressing [
Be aware that the data of overlay or macro that is already registered may be deleted.
Perform the following procedure.
1. Perform a soft reset.
Solution 2
2. After the soft reset, either perform a hard reset or turn the printer back ON, increase memory
capacity and print again. (All data in the memory will be erased.)
Output tray is full. Remove paper.
<Cause> The output tray is filled to the limit.
Solution Remove the paper in the output tray.
Paper is jammed.
<Cause> Paper is jammed inside the printer.
Remove the jammed paper and set the paper drawer and covers to the original position. If the printer is
not online, press [
"Clearing Paper Jams (Multi-purpose Tray)"
Solution
"Clearing Paper Jams (Paper Drawer)"
"Clearing Paper Jams (Duplex Unit)"
"Clearing Paper Jams (Inside the Output Area)"
"Clearing Paper Jams (Inside the Front Cover)"
IMPORTANT
If paper jams occur at multiple areas at the same time, the areas appear in the display by rotation.
If you removed the jammed paper without opening any cover, be sure to open and close the front cover once, and
then press [ ] (
"Canceling the Process Currently Being Performed (Soft Reset)"
"Canceling All the Jobs (Hard Reset)"
] ( : Online) to continue printing. However, the data with which an error is occurring is not
IMPORTANT
"Canceling the Process Currently Being Performed (Soft Reset)"
"Canceling All the Jobs (Hard Reset)"
] ( : Online).
: Online).
] ( : Online)