Canon LBP6780x Manual page 375

[Read Only] modes.
c. When using Community Name 2, select the check box for [Use Community Name 2], and set the following
items.
Set the SNMP Community Name in [Community Name 2]. Up to 32 characters can be entered. The
default setting is [public2].
Using [MIB Access Permission], select whether to operate the SNMPv1 agent in one of [Read/Write] or
[Read Only] modes.
When you are not using SNMPv1 protocol
Clear the [Use SNMPv1] check box.
IMPORTANT
When the [Use SNMPv1] check box is cleared
The following problems may occur.
* You may not be able to use some functions of Canon utility software or to use the software properly
due to an error occurring.
* You may not be able to specify or browse each option for this printer from utility software that uses
the SNMP v. 1 protocol to obtain information.
If you clear the [Use SNMPv1] check box, set it after consulting with the network administrator.
(2) Set a dedicated community.
For the setting of [Dedicated Community], select [Off], [Read/Write], or [Read Only].
To use Canon utility software, it may be necessary to select [Read/Write].
(3) Configure the SNMP v. 3 protocol.