KTM 1190 RC8 Owner's Manual page 143

MAINTENANCE WORK ON CHASSIS AND ENGINE
–
Remove bushing
and the shaft seal rings.
Long-life grease (
–
Fit the bushings.
–
Clean the thread of the wheel spindle and nut.
–
Clean the contact areas of the brake caliper support and swingarm.
700313-01
–
Push the brake caliper support
–
Position the rear wheel, and position the brake caliper support between the rim and the
brake disc.
–
Position the brake caliper on the brake disc.
–
Position the rear wheel on the bearing surfaces in the swingarm.
700314-01
and bushing . Clean and grease the roll surfaces of the bushing
 
p. 229)
completely to the rear.

141