Hdc Operation; Changing The Set Speed - Ford ENDEAVOUR Owner's Manual

HDC Operation

E206132
Cruise control switches on the steering
wheel allow you to control your hill descent
speed. SET + increases the speed and SET
- decreases the speed.

Changing the Set Speed

• Press and hold SET+ or SET-. Release
the control when you reach the desired
speed.
• Press and release SET+ or SET-. The
set speed will change in approximately
1 km/h increments.
Pressing the accelerator pedal or brake
pedal will increase or decrease the speed
respectively.
Note: Each gear has a pre-determined
minimum speed.
Note: Descent speed will only increase on
a slope steep enough to provide additional
momentum. Therefore, use of the SET+
switch on a gentle slope may not increase
the speed.
Note: The Brakes will override the HDC if
the brake pedal is pressed. The system
resumes on the release of the brake pedal.
Endeavour (TEC), EB3B-19G219-ZCA enIND
Hill Descent Control
Note: HDC assistance will fade out
gradually if you switch the system off. This
is to prevent the loss of control if you press
the HDC switch unintentionally. If assistance
is still required, you can switch back the HDC
on. The control will resume at a speed the
vehicle is travelling when the pedal is
released.
Note: You may hear a noise from the
system. This is normal.
Note: When HDC is operating, the ESC on
warning lamp will flash.
HDC operates only if the vehicle speed is
within the specified range even if the
system is on permanently during off-road
driving.
133