Operation; Starting Up; Information On The Operating Modes; Inserting The Battery - Quickie Attitude Directions For Use Manual

7.0 Operation

Starting up:

Information on the operating modes:

Essentially, the battery has two operating modes. It is
either in "Active mode" or in "Deep Sleep mode".
In Active mode the battery consumes at least 5 mA per
hour (consumption of the battery's own electronics).
To keep the battery's own consumption as low as
possible, the battery automatically switches to the
so-called Deep Sleep mode after 48 hours.

Inserting the battery:

• Place the battery [1] on the battery slide rail [6]
mounted on the add-on bike.
• Push the battery [1], as shown in the diagram, up to the
front edge of the battery slide rail [6].
• Lock the battery [1] by carefully turning the key [2]
clockwise until it stops. The battery can no longer be
removed from the battery slide rail.
• Remove the key [2] from the battery [1].

Connecting the battery to the motor cable:

• Insert the plug [7] of the cable coming from the motor
into the socket [3] on the battery [1].
• The two parts are correctly aligned and interlocked
automatically by means of a magnetic latch.
Before inserting the plug [7] in the socket [3],
ensure that both parts are clean and there are no
metallic particles on them. If you detect such
particles, use a dry, clean cloth to remove them.

Switching on the battery:

If the battery has been used within 48 hours it does not
need to be switched on. The Add-on bike is ready for use
and can be switched on via the sMMI and used.
If the battery is first being activated now, or if it has not
been used for more than 48 hours (Deep Sleep mode), it
needs to be switched on.
• Tap button [4].
• All the LEDs [5] flash three times to show it is switched
on.
• Your add-on bike is now ready for use and can be
switched on via the sMMI and used.
CAUTION!
If the motor cable is not yet connected to the battery, the
battery will still be in Active mode when switched on.
If the battery cannot be switched on, the cell voltage may
be too low. In this case connect the charger and then
press the on/off button [4]. The battery will be charged for
a minute.
Attitude/Attitude Hybrid Rev.1.0
Fig.7.1
1
Fig.7.2
7
Fig.7.3
6
2
3
4
5
43