Motor; Removing The Drive Wheel - Quickie Attitude Directions For Use Manual

CAUTION!
The motor must never be "forcibly cooled" externally with
water. This can lead to damage and does not help
especially with cooling as it is primarily the inside of the
motor that is hot.

Motor:

The drive wheel of your Attitude can be removed from the
bicycle frame at any time, for example, for cleaning
purposes or in case of a puncture. Proceed extremely
carefully when removing and subsequently installing the
drive wheel and note, in particular, the instructions and
information of the manufacturers of the various
components attached to the wheel, especially the brake
disc.
NOTE: For clarity reasons the following diagrams only
show the drive motor integrated in the wheel but not the
entire drive wheel.

Removing the drive wheel:

Note or mark the cable routing and the fixing points of the
cable ties before removing the drive wheel. First loosen
and remove all cable ties which are securing the cables
[16] coming from the motor and cables and leads of other
components to the bicycle frame. Then disconnect the
plug [15] on the cable of the motor [16] from the socket
[17] on the battery cable. Loosen the two nuts [18] or the
quick-release mechanism with which the wheel is fixed to
the frame so that the entire wheel can be removed from
the frame of your add-on bike.
CAUTION!
• Note or mark the position of the torque support [20].
This must be re-fitted in exactly the same position as it
was before removal, when you later attach the wheel.
• Never hold or transport the wheel you have removed
by the cable, [16] coming from the motor. There is a
risk of the cable breaking.
Attitude/Attitude Hybrid Rev.1.0
Fig.3.17
35