Information And Warning Symbols; Battery Capacity Display (Standard Display); Warning; Braking Assistant Active - Quickie Attitude Directions For Use Manual

Information and warning symbols:

As standard, in field [11], the remaining battery capacity
is displayed. But depending on the travel situation,
information and warnings as shown in the following may
also be displayed in this field.

Battery capacity display (standard display):

The remaining battery capacity is shown in stages by a
decreasing white bar.
Charging process of the battery:
1. The battery charger is plugged in and the battery is
being charged (only for battery models which are
charged via a second charging socket which is why the
power connection to the sMMI from the battery does not
need disconnecting).
2. The battery is being charged by energy fed by the
motor (recuperation, see also section 3.2.5).

Warning:

The battery is empty. No power can be taken from the
battery, motorised support for the add-on bike is no
longer available. Please charge the battery as soon as
possible using the supplied battery charger.

Braking assistant active:

During a downhill journey your Attitude brakes
automatically within the pre-set limits (see section 3.2.6).

Service reminder:

The service interval of your Attitude has lapsed. Please
arrange a service appointment with your specialist
dealer. The display can be reset by your dealer using
diagnosis software.
Warning – temperature problem:
For extremely long and steep ascents (primarily in Boost
mode) the drive generates heat, which results in an
automatic reduction in performance from a temperature
from +80 °C inside the motor. As a result of the intelligent
multipoint thermal management monitoring system (see
section 4), the motor will never overheat. The
performance is reduced to such an extent that damage is
excluded. In very rare cases (e.g. heat built-up from
external heat sources) the system may shut down
completely until temperatures return to within the
permissible operating range. When switching off the
display will show the thermometer symbol.
Warning – system fault:
Inside the warning symbol, instead of the exclamation
mark, various letters are shown (for instance the letter
"B" in the accompanying diagram), which mean the
following:
B = battery fault
C = communication fault in the system
M = motor fault
R = controller fault
When a fault occurs, motorised support is not available.
Please contact your specialist dealer.
Warning – general fault:
A fault has occurred in the system, motorised support is
no longer available. Please contact your specialist
dealer.
Attitude/Attitude Hybrid Rev.1.0
Fig.3.12
Fig.3.13
31