Easy Display Mode; Activating Easy Display; Deactivating Easy Display; Other Settings - Quickie Attitude Directions For Use Manual

Easy Display mode:

Fig.3.14
By activating Easy Display, the following graphical
symbols presented in section 3.2.2 are enlarged on the
display.
•• indication of the current speed travelled
•• indication of the daily kilometres travelled (requires
prior reset, see section 3.2.10)
•• indication of the remaining battery capacity including
indication of the expected remaining range
The relevant display can be selected by tapping button [2]
on the controller.
If buttons [1] or [3] are tapped, the display shows the
assistance level for about 3 seconds that can be
increased or decreased using the two buttons.

Activating Easy Display:

From the start menu you go via Menu – Settings – Easy
Display to display "on/off".
If Easy Display is activated, the sMMI automatically goes
into this mode every time it is switched on.

Deactivating Easy Display:

To deactivate the mode you need to press button [2] on
the controller for about 2 seconds. Via Menu – Settings –
Easy Display you arrive at the display "on/off".
NOTE: When Easy Display is activated the functions
"pushing aid" and "recuperation" are not available.

Other settings:

As standard, your sMMI has a German user interface.
However, if required, an English / Dutch / French interface
can be activated. The software status of the sMMI, the
motor and the battery pack can also be retrieved from the
menu item "information". Language activation or status
requests are performed similarly to the procedures
described in the previous sections via various menus and
sub menus.

USB port: (Fig.3.14)

The sMMI has a USB port [14], which is primarily used by
your specialist dealer to carry out maintenance and
diagnosis work. Ensure that the rubber cover is always
fully inserted and seals the port. If the sMMI is not
fully sealed, moisture can get inside or fog the display
from the inside.
In addition to English we can also set Dutch and French.
However, if required, an English / Dutch / French interface
can be activated.
Attitude/Attitude Hybrid Rev.1.0
32