Advertisement
ENGLISH
These instructions are valid for the following model:
TRIGON K
Thanks to the inside telescopic arm system, it is possible to
automate folding doors with two panels up to 3 m in length (1.5
m per panel).
The irreversible system mechanically locks the door when the
motor is not operating. A manual release allows the door to be
moved during a black-out or failure.
Electronic devices equipped with an electronic torque adjustment
device must be used in order to implement anti-crushing safety.
1. INSTALLATION PROCEDURE
1)
The operator is installed on the hinged panel directly to the
pilaster (fig. 2) or, when the door is open, if there is not enough
space behind the door for the operator, it should be installed
on the outermost panel (fig. 3). The installation dimensions
are valid in both cases.
6
7
9
Fig. 1
•measurements in mm
250
A
120±20
•measurements in mm
AUTOMATION TRIGON K
Application with telescopic arm for folding doors
8
3000 Max.
110±20
B
=
=
2)
Put the base plate A on the panel, observing the dimensions
as indicated in fig. 4 and weld or attach it to the panel using
4 screws.
3)
Find the position halfway on the second panel and install the
angle bar with pin B. Then weld or attach it using 2 screws
while following the dimensions show in fig. 4.
4)
Mount the geared motor C on the base plate A using the
relative screws, washers and nuts supplied (fig. 5). Note: the
grooved section must be facing up.
5)
Release the geared motor C and fit the telescopic arm D on
the grooved channel.
6)
Turn the telescopic arm by hand until the hole on the sheath
is on the pin of angle bar B. Fit it into position and lock it using
a seeger ring.
7)
Move the door by hand and make sure that none of the
installed parts strikes against the door or the pilasters.
8)
If necessary, shorten the sheath to remain within the limit of
50 mm as indicated in fig. 2 and fig. 3. Note: the sheath and
the internal element must have the same length.
2
1
4
5
•measurements in mm
Fig. 2
C
Fig. 4
8
3
1)
Guide tube
2)
Telescopic arm plate
3)
Telescopic arm fitting
4)
Operator fixing base plate
5)
Housing
6)
Release
7)
Release key
8)
Transmission shaft
9)
Gearmotor
3000 Max.
D
A
Fig. 3
B
Fig. 5
Advertisement
