Sub-Zero BI-36R Design Manual page 77

WINE ST O RAG E
Custom Panel—WS-30 | BW-30
DU AL INS TALL AT IO N S
A dual installation kit may be required if two models WS-30
or a model WS-30 and built-in unit are installed side by side,
or two models BW-30 or a model BW-30 and built-in unit.
Installations without a custom filler strip require a dual instal-
lation kit. If a dual installation kit is not specified, a 2"
filler strip is recommended between units. Dual installations
without a filler strip can only be accomplished using two
units with opposite hinges. Refer to the illustrations below.
Dual installation kits are available through an authorized
Sub-Zero dealer. For local dealer information, visit the find a
showroom section of our website, subzero.com. For ques-
tions regarding the installation, call Sub-Zero customer care
at 800-222-7820.
For dual standard installations, panel dimensions are the
same as for single installations. Refer to the chart on page
74. Panel dimensions and offsets for dual flush inset instal-
lations are listed on the following pages.
WITHOUT FILLER STRIP
Opposite hinges.
(51)
FILLER STRIP
Same side hinges.
D U A L FL U S H I N S E T PA N E L D IM E N S I ON S
H
A
A A H
A
W
WS-30, BW-30
D UA L FLU S H I NS E T PAN EL S
D OOR
Flush Inset Panel
Spacer Panel
Backer Panel
GRILL E
Flush Inset Panel
Spacer Panel
Backer Panel
STI LES | RAILS
Minimum
Grille panel dimensions are for standard 84"
83" height, subtract 1" ) from grille panel height dimensions and for
(2108) (25
88" height, add 4" . A specific panel grille must be ordered for an
(2235) (102)
83" or 88" overall unit height.
W H
30 1 / " 69 3 / "
(775) (1772)
2 4
29 1 / " 68 15 / "
(740) (1751)
8 16
29 3 / " 69 9 / "
(756) (1767)
4 16
W H
30 1 / " 9 1 / "
(775) (235)
2 4
1 5
29 / " 8 / "
(740) (211)
8 16
29 3 / " 8 15 / "
(756) (227)
4 16
A
3 3 / "
(95)
4
overall unit height. For
(2134)
|
subzero.com/specs 77