Sub-Zero BI-36R Design Manual page 21

BUILT-I N RE FR IG E R AT ION
Custom Panels
FLUS H IN SE T PA NE L S
The flush inset application is an overlay model with flush
inset panels. It is not a separate model.
The flush inset design allows custom panels to be installed
flush with adjacent cabinets. Similar to overlay, flush inset
panels are typically created by combining a
panel, a .10" spacer panel and a
(3)
Refer to the illustrations for overlay panels.
For flush inset panels thicker than
may be required to prevent interference with adjacent
cabinets. Refer to the full-scale templates at the end of this
guide.
When installing two units side by side, refer to page 17 for
dual flush inset installations.
3 / " custom
(19)
4
1 / " backer panel.
(6)
4
3 / " , a 90° door stop
(19)
4
I C E A N D WATE R D I S P EN S E R
For models BI-42SD and BI-48SD, the refrigerator door
panel must include a cut-out to accommodate the external
dispenser. The thickness of the panel in this area can range
from 1 / " to a maximum of 1
(6)
4
tions below.
5 3
/ " / "
8 32
(16)
(2)
5
6 / "
16 (160)
12 7 / "
8
(327)
Dispenser dimensions.
2"
(51)
HANDLE
GLASSWELL
1"
(25)
Handle placement.
1 / " . Refer to the illustra-
(29)
8
3
/ "
16
(5)
5
6 / "
16 (160)
7
12 / "
8
(327)
Dispenser dimensions.
|
subzero.com/specs 21