Step 4 Install The Camera - Canon VB-C500VD Start Manual

Step 4 Install the Camera

Note on Use before Installing the Camera
Be sure to install the camera after setting the IP address (
Note
The camera will stop issuing IP address assignment requests in 20 minutes after its power
is turned on, upon which detection by VB Initial Setting Tool will be disabled. Before
installing the camera, set the IP address and check the operation by referring to "Perform
Initial Setting of the Camera" (
The unique MAC address of this camera is specified at the bottom of the camera
( P. 1-20). It is recommended to write down the MAC address before installing the
camera.
For installation or inspection of the VB-C500VD/VB-C500D, consult/request the
store where you purchased the product.
• Wire the VB-C500VD/VB-C500D power supply, network, or other cables safely
and securely according to the relevant regulations such as technical standards
for electrical installations.
• When installing the VB-C500VD/VB-C500D, select a ceiling surface, etc.,
capable of withstanding the total weight of the camera and all options used
(Recessed Mounting Kit), provide sufficient reinforcements and use the
bundled safety wire if necessary.
• To prevent injuries and equipment damage due to falling items, periodically
check the brackets and screws for rusting and loosening.
• Do not install the VB-C500VD/VB-C500D to the place with strong vibration.
• Do not install the VB-C500VD/VB-C500D on the uneven, inclined, or other
unstable surface.
• (VB-C500VD) Do not install the network camera to the place where is not
strong enough or where is easily affected by vibration. Otherwise, the vandal
resistant feature may not be made the best use of.
Malfunction may result.
P. 2-10).
P. 2-10).
Note
2-15