Christie DS+5K User Manual page 74

Section 3: Operation
System Configuration
DIAGNOSTICS / CALIBRATION
3-46
Downloaded from ProjectorsManual.com Manuals
hardware, by matching up black level hues with a "target area" hue (the intersection of
the center lines), and adjusting the overlaps (edges) surrounding the target area.
NOTES: 1) Refer to section 3.10, Using Multiple Projectors for additional
information. 2) There is a centerline (both horizontal and vertical) in the Black Level
Blending test pattern. The intersection of these lines is the true center of the
projector's display area. 3) Adjust white levels before adjusting black levels. 4)
Blinders are recommended for fixed installations.
Default Color Adjustments
Refer to System Configuration – Geometry and Color, Color Adjustments by X,Y for
description.
Intelligent Lens System (ILS
ILS™ provides the ability to recall focus and zoom settings specific to each source
input. Custom lens settings you've chosen for any source will be quickly and
accurately applied when you select a source that has already been calibrated. Place a
checkmark in the checkbox to enable ILS™. If no calibration has previously been
done you may be prompted to do a full calibration. If a motion calibration has been
done, you will be prompted to complete a reference calibration. If both calibrations
have been done, the checkbox will be checked and ILS™ enabled. If ILS™ is enabled,
a reference calibration will be done on power up and the lens will return to the saved
position of the source that is active at the time of power up or to the position the lens
was located when it was powered on. Further adjustments to the zoom, focus and
position will be automatically saved for source the selected source. If you switch to a
source with different lens settings and switch back, the lens will automatically move
to your saved settings upon return. Other sources can be used without using ILS™ .
NOTES: 1) See System Configuration – Diagnostics/Calibration, ILS Calibration
for further details about calibration. 2) ILS
be retained between power cycles.
Test Pattern
Choose the desired internal test
pattern to display, or select OFF to
turn off a test pattern. Alternatively,
use the key for cycling through
Test
test patterns.
NOTE: There is a centerline (both
horizontal and vertical) in the Edge
Blending test pattern. The
intersection of these lines is the true
center of the projector's display
area.
Test Pattern Grey Level
Set the desired level of grey for displaying in the full gray field test pattern.
— SUBMENU
™
)
— SUBMENU
™
control is a preference setting and will
013-100199-04