Christie DS+5K User Manual page 108

Section 4: Maintenance
4-8
Downloaded from ProjectorsManual.com Manuals
5. REMOVE THE LAMP MODULE
Firmly grasp the lamp by its housing only and pull it straight out (lamp slides
along guides) until it is free. See Figure 4.4. Discard the lamp using safe
disposal/recycling practices.
Figure 4.4. Remove Lamp Module
6. INSERT THE NEW LAMP MODULE
Align the new lamp with the top and bottom guides on the left side of the lamp
compartment (see Figure 4.5). Slide the lamp all the way in – a slightly harder
push may be required right at the end to ensure it's fully seated into the terminal
block.
NOTE: The lamp module must make full contact with the terminal block. The
projector will not power up again if the lamp is not fully connected to the terminal
block.
Improper installation could cause a serious
7. LOCK IN THE NEW LAMP MODULE
Pull out and turn the lamp lock lever (turned up in Step 4) ¼ turn clockwise to
"lock" the lamp in place.
Figure 4.5. Insert New Lamp Module
WARNING
meltdown inside the projector.
013-100199-04