Barco PH series User And Installation Manual page 96

9. Advanced features
Image 9-9
A To REMOTE 1 IN
B RS-232C cable (option)
C Control panel
1. Connect one end of an RS-232C cable to the REMOTE 1 IN terminal on the projector.
2. Connect the other end of the RS-232C cable to the control panel.
Pin functions (defaults)
Connect the other end of the RS-232C cable to the control panel.
Pin No.
1
2
3
4
5
6
7
8
9
→ You can change the functions of PIN 2 to PIN 8 using REMOTE 1 MODE in the INSTALLATION 2 menu.
Important:
To reset the pin functions to the defaults, set REMOTE 1 MODE in the INSTALLATION 2 to RESET.
Contact control
By short-circuiting Pin No. 1 and Pin No. 9, you can control the projector using a control panel or other device.
When you short-circuit Pin No. 1 and Pin No. 9, the following functions cannot be used:
• POWER and BLANK of the remote control and the projector
• RS-232C commands and network functions corresponding to the above-mentioned functions
• REMOTE 1 MODE, AUTO POWER ON and AUTO POWER OFF in the INSTALLATION 2 menu.
• STANDBY MODE in the INSTALLATION 1 menu.
Input switching control
By short-circuiting any of Pin No. 3 to Pin No. 7, you can switch the input using a control panel or other device.
When short-circuiting any of Pin No. 3 to Pin No. 7, you cannot use the following functions.
• POWER, BLANK, COMPUTER 1, COMPUTER 2, VIDEO, S-VIDEO, DVI, HDMI, and SDI (for PHWU-81B only) of the remote
control and the projector
• RS-232C commands and network functions corresponding to the above-mentioned functions
POWER control
By short-circuiting or open-circuiting Pin No. 2, you can turn on or off the power using a control panel or other device.
BLANK control
By short-circuiting or open-circuiting Pin No. 8, you can turn on or off the BLANK function using a control panel or other device.
92
Downloaded From projector-manual.com Barco Manuals
A
B
Signal
GND
POWER
Input
Input
Input
Input
Input
BLANK
ON/OFF
C
Open (H)
-
OFF
-
-
-
-
-
OFF
Valid (Remote control)
Short (L)
GND
ON
COMPUTER1
COMPUTER2
VIDEO
S-VIDEO
DVI
ON
Invalid (External contact control)
R5905597 PHXX SERIES 20/05/2014