Information Menu - Barco PH series User And Installation Manual

5. Advanced menu
Item
NETWORK
CERTIFICATION
IP CONFIG
DHCP
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
MAC ADDRESS
SAVE SETTINGS
CONTROL SYSTEM
NETWORK RESET
NETWORK RESTART
• AMX does not support network certification. When setting CONTROL SYSTEM to AMX, set NETWORK CERTIFICATION to
OFF.

5.10 INFORMATION menu

Overview
IMAGE INSTALL1 INSTALL2 MULTI-
LAMP 1 TIME (LOW)
LAMP 2 TIME (LOW)
NEXT LAMP RELAY
FILTER TIME
SERIAL NUMBER
INPUT
RESOLUTION
VERTICAL
FREQUENCY
HORIZONTAL
FREQUENCY
SYNC. TYPE
Image 5-20
Item
LAMP 1 TIME (LOW)
52
Downloaded From projector-manual.com Barco Manuals
Setting
ON / OFF
ENTER
ON
OFF
***.***.***.***
***.***.***.***
***.***.***.***
xx-xx-xx-xx-xx-xx
OK
STANDARD
AMX
CRESTRON
OK
OK
SCREEN FEATURE SIGNAL NETWORK INFO
H
****
H
****
D H
* **
H
*****
...
********
COMPUTER1
1024 x 768
60.00 Hz
48.36 kHz
5 WIRE
Description
This item shows the lamp operation time calculated based on that the LAMP MODE of LAMP
1 is LOW.
→ When the LAMP MODE is STANDARD, this item shows a longer lamp operating time than
the actual time.
→ When the lamp operating time is 0 to 10 hours, "0H" is displayed. The lamp operating time
exceeding 10 hours is indicated by the actual hours.
→ When the lamp operating time reaches 3000 hours, the bar turns to yellow. When it reaches
3800 hours, the bar turns to red.
→ The icon displayed to the right of the bar shows the lamp status. Yellow: On, Red: End of lamp
life or error such as illumination failure, Black: Off
Function
Select whether to enable the network certification or not. Select OFF
for normal use.
Select this setting for IP Configuration.
Select this setting when you obtain IP CONFIG automatically by
DHCP server.
Select this setting when you set IP CONFIG manually.
Press the ENTER key to set IP ADDRESS. When DHCP is set to ON,
you cannot change this setting.
Press the ENTER key to set SUBNET MASK. When DHCP is set to
ON, you cannot change this setting.
Press the ENTER key to set DEFAULT GATEWAY. When DHCP is set
to ON, you cannot change this setting.
Displays MAC ADDRESS.
Saves the IP CONFIG settings. When the IP CONFIG is not changed,
you cannot select SAVE SETTINGS.
Select this setting when using Projector Toolset.
Select when using a controller made by AMX.
Select this setting when using the controller or software of Crestron
Electronics, Inc.
Resets the Network Setting.
Press the ENTER key to restart the network function.
R5905597 PHXX SERIES 20/05/2014