Remote Controller Specifications - Toyotomi TKN/TKG-A528DV User Manual

REMOTE CONTROLLER

REMOTE CONTROLLER SPECIFICATIONS

Model
Rated Voltage
Signal receiving range
Environment
1. ON/OFF Button. Operation starts when this button is pressed and stops when this button is
pressed again.
2. MODE Button. Each time the button is pressed, the operation mode is selected in a sequence
of following: AUTO
3. SWING Button. Used to stop or start horizontal louver auto swing feature.
4. DIRECT Button. Used to change the louver movement and set the desired up/down air fl ow
RG36A(1)/BG(C)EF
3,0V (dry batteries R03/LR03x2)
8 meters
-5º~60ºC
COOL DRY HEAT
direction. The louver changes 6in angle for each press.
5. SLEEP/PLASMA Button. Active/Disable SLEEP
function. If pushing more than 2 seconds, the
PLASMA function will be activated, pushing more
than 2 seconds again to disable.
NOTE: While the unit is running under SLEEP mode, it
would be cancelled if press the MODE, FAN SPEED or
ON/OFF button.
6. TURBO/SELF CLEAN Button: Active/Disable TURBO
function. If pushing more than 2 seconds, the SELF
CLEAN function will be activated, pushing more than
2 seconds again to disable(depending on models).
7. RESET Button: When you press the recessed RESET
button, all current settings are cancelled and the
control will return to the initial settings.
8. UP Button (+). Push this button to increase setting
temperature in a range of 17 ºC~30 ºC.
9. DOWN Button (-): Push this button to decrease setting
temperature in a range of 17 ºC~30 ºC.
10. E/S (Energy Saving) Button.
Use this button to enter the energy effi ciency mode.
Under cooling mode, press this button. The remote
controller will adjust the temperature automatically to
24ºC, fan speed of Auto to save energy but only if the
set temperature is less than 24ºC. If the set temperature
is between 24ºC and 30ºC, press the E/S button. The
fan speed will change to Auto, the set temperature will
remain unchanged.
52
FAN .
GB