REMOTE CONTROLLER
HANDLING THE REMOTE CONTROLLER
Location of the remote controller.
Use the remote controller within a distance of 8meters from the appliance, pointing it towards the
receiver. Reception is confi rmed by a beep.
CAUTION
The air conditioner will not operate if curtains, doors or other materials block the signals from the remote
controller to the indoor unit. Prevent any liquid from falling into the remote controller. Do not expose the
remote controller to direct sunlight or heat. If the infrared signal receiver on the indoor unit is exposed to
direct sunlight, the air conditioner may not function properly. Use curtains to prevent the sunlight from
falling on the receiver. If other electrical appliances react to the remote controller. either move these
appliances or consult your local dealer.
Replacing batteries
NOTE: Replace the batteries when there is no receiving beep from the indoor unit or if the transmission
indicator on the remote controller fails to light.
The remote controller is powered by two dry batteries(R03/LR03X2) housed in the rear part and protected
by a cover.(1) Remove the cover by pressing and sliding off .(2) Remove the old batteries and insert the
new batteries, placing the(+) and (-)ends correctly.(3) Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the remote controller erases all programming. After inserting
new batteries, the remote controller must be reprogrammed.
CAUTIONS
•
Do not mix old and new batteries or batteries of diff erent types.
•
Do not leave the batteries in the remote controller if they are not going to be used for 2 or 3 months.
•
Do not dispose batteries as unsorted municipal waste. Collection of such waste separately for
special treatment is necessary
REMOTE CONTROLLER SPECIFICATIONS
Model
Rated Voltage
Signal receiving range
Environment
RG36A(1)/BG(C)EF
3,0V (dry batteries R03/LR03x2)
8 meters
o
o
-5
C~60
C
37
GB