Making The Connection; Ethernet Interface; Using Dhcp - Oki mc160n Network Manual

Making the Connection

Ethernet Interface

An RJ45 connector can be used as the Ethernet interface for this machine.
When connecting your machine to an Ethernet network, the tasks you per-
form depend on how you plan to set the machine's IP (Internet Protocol)
address.
IP Address—A unique identifier for each device on a TCP/IP network.
Subnet Mask—A filter used to determine what subnet an IP address
belongs to.
Gateway—A node on a network that serves as an entrance to another
network.
Since the IP address for each PC and machine on your network must be
unique, you usually need to modify this preset address so it doesn't conflict
with any other IP address or your network or any attached network. You can
do this in one of two ways. Each is explained in detail in the following sec-
tions.

Using DHCP

Setting the address manually
Using DHCP
If your network supports DHCP (Dynamic Host Configuration Protocol), the
machine's IP address will be automatically assigned by the DHCP server
when you turn on the machine. (Refer to "Network Printing" on page 2-6 for a
description of DHCP.)
1
Connect your machine to the network.
When using an Ethernet cable, plug the RJ45 connector into the Ethernet
interface port of the machine.
2
Turn on your PC and machine.
3
After the machine's message window is initialized, install the printer driver.
Network Connection
Downloaded From ManualsPrinter.com Manuals
If the IP address of the machine is not set automatically, check if the
machine has been set to allow DHCP to be used (
— —
REPORT CONFIGURATION PAGE
set so that DHCP cannot be used, select
ADMIN. MANAGEMENT - NETWORK SETTING - IP ADDR.
SETTING menu, and
AGEMENT - NETWORK SETTING - DHCP
AUTO
ENABLE in the UTILITY - ADMIN. MAN-
REPORT/STATUS
). If the machine has been
in the
UTILITY -
menu.
2-3