Rear Panel - Marantz PM8003 User Manual

ENGLISH
NAMES AND FUNCTIONS

REAR PANEL

PHONO PRE OUT POWER AMP
DIRECT IN
GND
L L L
R R R
CD TUNER AUX RECORDER 1 RECORDER 2
/ DVD IN OUT IN OUT
L L
R R
PHONO Input jacks
These jacks are for connecting to an analog record
player. MM cartridges can be used.
PHONO GND terminal
Connect the grounding wire from an analog record
player.
PRE OUT jacks
These jacks are for connection via the input jacks of
another main amplifier or active subwoofers. These
jacks cannot be used in Power Amp Direct mode.
POWER AMP DIRECT IN jacks
These jacks are used as input jacks when you use
this unit as a power amplifier in Power Amp Direct
mode. If you use another preamplifier, connect it via
these jacks. In this status, the sound volume cannot
be adjusted by turning the VOLUME knob.
6
SPEAKERS
SYSTEM A
MODEL NO. PM8003
R L
AC IN
REMOTE
CONTROL
IN
OUT
R L
SPEAKERS SYSTEM A, B
output terminals
You can connect 2 speaker systems, SYSTEM A and
SYSTEM B. Speaker output can be turned ON/OFF
from the SPEAKERS knob on the front panel.
AC IN socket
Connect the supplied AC power cable to this socket
and a power outlet.
REMOTE CONTROL jacks
These jacks are for connecting to other Marantz
components such as a CD player or DVD player that
has a remote control connector (D.BUS jack).
You can use the remote controller supplied with the
unit to control the system.
For more details, see page 11.
RECORDER 1/RECORDER 2 output
jacks
These jacks are for connecting to the recording input
jacks of a CD-R recorder, MD deck, tape deck, etc.
RECORDER 1/RECORDER 2 input
jacks
These jacks are for connecting to the output jacks of
a CD-R player, MD deck, tape deck, etc.
AUX/DVD input jacks
These jacks are for connecting to the output jacks of
a DVD player or other audio component.
TUNER input jacks
These jacks are for connecting to the output jacks of
a tuner or other audio component.
CD input jacks
These jacks are for connecting to the output jacks of
a CD player or similar component.