Administrator Setup - HighSecLabs K404F User Manual

Administrator Setup

Now that the Secure Combiner KVM is connected and powered-on
it is a good opportunity to setup some operational settings.
To enter administrator setup mode the administrator key should be
inserted into the front panel keylock and rotated in clockwise
direction. Once in administrator clicks on setup icon at the bottom
left side of the screen, the Main Admin Setup windows appears and
can be accessed. Details about administrator setup windows:

Main Admin Menu – Enables selection of System setup
window or channel specific window using mouse.

Channel menu – Enables selection of channel input
resolution (4 options) and border color from 16 color
options.

System menu – Enable system level settings. Administrator
can select:
- Display output resolution from 2/6/8 options;
- Border width from 6 options;
- Taskbar size from 2 options; and
- System cursor type from 4 options.
Note: Rotation of the key lock to Administrator setup mode also
affect: the following:
1. User preset buttons will become inactive.
2. All three user presets will be erased.
This is normal system behavior that designed to avoid configuration
conflicts.
19
Secure Combiner KVM Switch User Manual
Note about input resolution setting: Selection of input resolution
that does not match the attached PC will result unreadable image at
that window. This may be fixed by entering administrator mode and
change input resolution setting or by changing host resolution.
Notes about display resolution setting:
- The Secure Combiner KVM channel resolution, selected from the
channel menu, determines the size of the channel window. It will not
affect the actual resolution projected by the connected PC.
- The Secure Combiner KVM is capable of scaling the image in two
possible factors: 2x and 4x allowing the user to fit more information
on the same display size.
- Selection of resolution higher or lower than resolution range of
connected display may result image loss! In this case you can change
display to different type or restore factory defaults.
- To restore factory default settings – use a paper clip or another
sharp object and press momentarily the recessed RFD switch located
at the rear side above the DC power jack.
- See table in page 14 for supported output resolutions per model.
Once completed to set the required settings, the administrator key
should be rotated back to the locked position and key must be
removed to enable normal product operation.
After Installation Checklist
Once completed to set requires settings – check the final device
product configuration with all connected computers operating:
1. Check that each window is connected to the proper PC and have
the required border color.
2. Check that each window is coupled to the proper keyboard and
mouse (no cables are crossed between channels).
3. Check that each window is coupled to the proper DPP input.