Table of Contents
Advertisement
RIP C
OMMANDS
-
4 (RIP)
ADDRESS
FAMILY IPV
address-family ipv4 (RIP)
Overview
This command enters the IPv4 address-family command mode. In this mode you
can configure address-family specific parameters for a specific VRF (RIP) instance.
address-family ipv4 vrf <vrf-name>
Syntax (VRF lite)
no address-family ipv4 vrf <vrf-name>
Mode
Router Configuration
Usage
To leave Address Family mode and return to Router Configuration mode, use the
exit-address-family
Example
In this example the address family "green" is entered, and then exited by using the
exit-address-family command. I
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router-af)#
awplus(config-router-af)#
awplus(config-router)#
Related
exit-address-family
Commands
C613-50079-01 REV A
Parameter
Description
ipv4
Configure parameters relating to the RIP exchange of IPv4 prefixes.
vrf
Apply this command to a VRF instance.
<vrf-name>
The name of the VRF instance.
command.
configure terminal
router rip
Command Reference for AT-DC2552XS/L3
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
address-family ipv4 vrf green
exit-address-family
exit
763
Advertisement
Table of Contents
