Terminal Panel Features - NEC NP3150 User Manual

Terminal Panel Features

14
The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not af-
fect the projector's performance.
. COmpUTER  IN/Component Connector (mini
D-Sub 5 pin) (→page 4, )
AUDIO IN (Stereo mini Jack) (→page 4, 5, )
. COmpUTER  IN/Component (R/Cr, G/Y, B/Cb, h,
V) Connectors (BNC x 5) (→page 4)
AUDIO IN (Stereo mini Jack) (→page 4)
3. COmpUTER 3 (DVI-D) IN Connector (4 pin)
(hDCp compatible) (→page 5)
AUDIO IN (Stereo mini Jack) (→page 5)
4. COmpONENT IN (Y, Cb/pb, Cr/pr) Connectors
(RCA) (→page )
AUDIO L/mONO, R (RCA) (→page )
5. S-VIDEO IN Connector (mini DIN 4 pin) (→page
8)
. VIDEO IN Connector (RCA) (→page 8)
. VIDEO/S-VIDEO AUDIO L/mONO, R (RCA) (→page
8)
8. mONITOR OUT Connector (mini D-Sub 5 pin)
(→page )
Downloaded From projector-manual.com NEC Manuals
4 13 12
USB(LAN)
5 6 7 1
9. AUDIO OUT (Stereo mini Jack) (→page )
0. pC CONTROL port (D-Sub 9 pin) (→page 4, 4)
. Remote Jack (Stereo mini Jack) (→page )
. USB port (Type A) (→page 3)
3. LAN port (RJ-45) (→page 9, 05)
4. USB Wireless LAN unit (→page 48)
8
3 2
8 9 11
Use this port to connect your PC or control system
to control your projector via a serial cable. This
enables you to control the projector using serial
communication protocol. A commercially available
RS232C cross cable is required to use this port. You
can also control the projector by using PC Control
Utility 3.0 contained on the supplied User Support-
ware 5 CD-ROM. To do so you must first have PC
Control Utility 3.0 installed on your PC. If you are
writing your own program, typical PC control codes
are on page 146.
NOTE: Connecting the remote cable to the REMOTE mini
jack on the terminal panel will make the wireless operation
unavailable.
NOTE: A dummy cover is provided on this location of the
projector without the USB Wireless LAN Unit.
1. Introduction
10