Wayne VIP Series Operating Instructions Manual

READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL - DO NOT DISCARD.
Failure to follow these instructions could result in property damage, serious injury or death.
DESCRIPTION
This portable, submersible utility pump is designed and in tend ed for
non-automatic use in water. The units are equipped with an 8-ft. 3-prong
ground ing-type power cord. The motor is oil filled and sealed for cooler
running and designed to operate under water. The non-clogging impeller
design minimizes debris from stopping the pump. The elbow fitting allows
convenient discharge through a garden hose.
IMPORTANT: THIS PUMP IS NOT SUITABLE FOR AQUATIC LIFE!
UNPACKING
After unpacking the sumbersible utility pump, carefully inspect for any
damage that may have occurred during transit. Check for loose, missing
or damaged parts.
SAFETY GUIDELINES
To help recognize this information, observe the following signal words/
hazard classifications.
DANGER indicates an imminently hazardous
situation which, if NOT avoided, WILL result in
death or serious injury.
WARNING indicates a potentially hazardous
situation which, if NOT avoided, COULD result in
death or serious injury.
CAUTION indicates a potentially hazardous
situation which, if NOT avoided, MAY result in
minor or moderate injury.
NOTICE indicates important information, that if
NOT followed, MAY cause damage to equipment.
This is the safety alert symbol. It is used to alert you to potential
bodily injury hazards. Obey all safety messages that follow this
symbol to avoid possible harm.
NOTE: Information that requires special attention.
GENERAL SAFETY INFORMATION
CALIFORNIA PROPOSITION 65
This product contains chemicals known to the
state of California to cause cancer or birth
defects or other reproductive harm. California's Proposition 65 requires
this warning to be given to customers in the state of California.
GENERAL SAFETY
1. Read manual included with this product carefully. Be
thoroughly familiar with the controls and the proper use
of the equipment.
2. Know the pump application, limitations, and potential
hazards. Read these rules and the instructions carefully. Failure
to follow them could cause serious bodily injury and/or property
damage.
REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.
© 2016,
WAYNE/Scott Fetzer Company.
Submersible Utility Pumps
OPERATING INSTRUCTIONS
For parts, product & service information visit www.waynepumps.com
Do NOT use to pump flammable or
explosive fluids such as gasoline,
fuel oil, kerosene, etc. Do not use in a flammable and/or
explosive atmosphere. Pump SHOULD be used to pump clear
water ONLY. Personal injury and/or property damage COULD
result.
3. Make certain that the power source con forms to the requirements of
the equipment.
Disconnect power be fore ser vic ing.
If the power dis con nect is out of
sight, lock in the open (OFF) po si tion and tag it to prevent
un ex pect ed ap pli ca tion of pow er. Fail ure to do so COULD
result in fa tal elec tri cal shock!
4. Release all pressure within the system before ser vic ing any
component.
5. Drain all liquids from the system before servicing.
6. Secure the discharge line before starting the pump. An unsecured
discharge line will whip, possibly caus ing personal injury and/or
property damage.
7. Check hoses for weak and worn condition before each use, making
certain that all connections are secure.
8. Periodically inspect the pump and system com po nents. Perform
routine maintenance as required (See Main te nance Section, on page
3).
This utility pump is not constructed to handle
laun dry discharge or any other application
which may contain caustic chemicals and/or foreign ma te ri als. This
pump is NOT a pond or waterfall pump – use of the pump in these
applications will void the warranty. Pump damage COULD occur if the
pump is used in these ap pli ca tions.
9. Provide a means of pressure relief for pumps whose discharge line
can be shut-off or obstructed.
10. Personal Safety:
a. Wear safety glasses at all times when working with pumps.
b. Keep work area clean, uncluttered and prop er ly light ed; replace all
unused tools and equipment.
c. Keep visitors at a safe distance from the work area.
11. When using an electrically driven pump such as this, follow all
electrical and safety codes, as well as the most recent National
Electrical Code (NEC) and the Oc cu pa tion al Safety and Health Act
(OSHA).
12. This equipment is only for use on 120 volt (single-phase) and
is equipped with an ap proved 3-conduc tor cord and 3-prong,
grounding-type plug as shown in Figure 1.
To reduce the risk of electric shock, the motor must be securely and
adequately grounded. This can be ac com plished by inserting pump
1
VIP Series
3200 06 -001 4/16