M REVERSE FEED SOLENOID ADJUSTMENT
Loosen screw O-
Turn the feed regulator dial to the maximum stitch length setting.
Raise the reverse feed solenoid plunger O until it meets the back of the solenoid O.
Completely lower the reverse lever O-
Tighten screw O-
An excessive gap between the solenoid base and reverse feed solenoid plunger will decrease the
strength of the magnet and may prevent reverse sewing.
Reverse switch adjustment
1. Loosen screw O- and position the pushbutton O where
it is easy to reach.
2.
Firmly tighten the screw O-
3.
Loosen nut o
and turn screw O to adjust the
pushbutton so that the switch is activated when
pressed.
-36 -