Table of Contents
Advertisement
[U REVERSE MECHANISM
Reverse switch cord
Thread wiper cord
Reverse solenoid
Procedures
1.
Install rear cover O with two screws O-
2.
Set the reverse crank O fork on the reverse solenoid plunger O-
3.
Secure the reverse crank O to the solenoid base O with screw O.
4.
Secure solenoid base O with screw O-
5.
Secure reverse link O and reverse crank O with screw O.
6.
Secure the cords with the cord clamp (£) and screws ®.
7.
Install reverse solenoid cover ® with screw ®.
8.
Install terminal pin to the 12-pin plug.
Terminal pm (black)
12-pin plug
o
o
o
•
o
o
o
o
o
o
o
Terminal pin (white)
8B REVERSE ASSEMBLY ADJUSTMENT
1.
Set the feed regulator dial to the maximum setting.
2.
Loosen screw © and raise the reverse solenoid
plunger O until it hits the back of the cylinder.
Pull the reverse handle ® all the way down, and firmly
tighten the set screw ©.
- 2 3 -
Hide quick links:
Advertisement
Table of Contents
