Draining The Rear Brake Circuit - PEUGEOT Django 125 Workshop Manual

Drain the braking circuit

Draining the rear brake circuit:

- Remove the master-cylinder cover. See:
Procedure 10. page 25.
Protect plastic parts that can be splashed
by brake fluid.
- Remove the cover and the diaphragm from the
master cylinder.
• 2 screw.
- Using the syringe, empty the LH master cylinder.
- Position the handlebars so that the master
cylinder will be horizontal.
- Fill the syringe with brake fluid.
- Connect the syringe to the bleed screw of the rear
calliper.
- Open the bleed screw by 1 to 2 turns.
- Inject the brake fluid slowly into the circuit until the
level inside the reservoir of the master cylinder is
halfway up.
- Close the bleeder screw.
Add brake fluid until it reaches the
maximum level.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
SERVICE OPERATIONS
57