Rear Brake - PEUGEOT Django 125 Workshop Manual

- Remove the brake pad pin (2).
- Remove the brake pads (3).
When refitting the brake pads, push the
pistons all the way into their housing.
After refitting, actuate the brake levers
several times to bring the brake pads
against the brake disc.

Rear brake

When changing the brake pads, it is
essential
attachment system (spindle, pin, clips, ...)
- Remove the wheel trim.
- Remove the 5 screws fastening the rear wheel.
Tightening torque: 30 Nm.
- Remove the brake caliper (2 screw).
Tightening torque: 30 Nm.
When refitting the brake caliper, spread
standard thread lock on the bolts.
- Squeeze the caliper holder in order to remove the
first brake pad (1).
- Remove the second brake pad (2).
- Remove the brake pad spring (3).
When refitting the brake pads, push the
pistons all the way into their housing.
After refitting, actuate the brake levers
several times to bring the brake pads
against the brake disc.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
to replace the brake pad
3
1
SERVICE OPERATIONS
2
2
3
49