PEUGEOT Django 125 Workshop Manual page 72

- Install new ball cage bearings (no special
direction).
- Install the upper cone (8).
- Install the dust cover (7).
- Fit the plain washer (6).
- Fit the first nut (5).
Tightening torque: 40 Nm.
- Loosen and re-tighten the steering head nut (5).
Tightening torque: 18 Nm.
- Install the rubber washer (4).
Do not tighten the steering nut beyond the
recommended value to avoid damanging
the steering bearings.
- Fit and finger tighten the nut (3) so that its notches
are aligned with those of the nut.
- Fit the lock washer (2) in the notches of the
locknut and adjustable cone.
- Install the steering head locknut and tighten it.
Tightening torque: 75 Nm.
- Check that there is no play in the fork.
- Turn the fork from left to right to check that there
are no tight spots.
- Refit the other items in the reverse order to
disassembly.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
4
6
8
2
STEERING/FORK
5
7
9
3
71