Table of Contents
Advertisement
RAID Configuration
On the RAID List screen, press the RAID
Config button to go to the RAID
Configuration screen. In addition to RAID
disk information and status, this screen lets
you make RAID configuration settings.
For more information on RAID, see
Appendix C: RAID
RAID Level
You can set the storage volume as JBOD, RAID 0, RAID 1, RAID 5, RAID 6 or
RAID 10. RAID configuration is usually required only when you first set up the
device. A brief description of each RAID setting follows:
RAID Levels
Level
JBOD
RAID 0
RAID 1
RAID 5
RAID 6
RAID 10
WARNING
Basics.
Description
The storage volume is a single HDD with no RAID support. JBOD
requires a minimum of 1 disk.
Provides data striping but no redundancy. Improves
performance but not data safety. RAID 0 requires a minimum of
2 disks.
Offers disk mirroring. Provides twice the read rate of single
disks, but same write rate. RAID 1 requires a minimum of 2
disks.
Data striping and stripe error correction information provided.
Excellent performance and good fault tolerance. RAID 5 requires
a minimum of 3 disks. RAID 5 can sustain one failed disk.
Two independent parity computations must be used in order to
provide protection against double disk failure. Two different
algorithms are employed to achieve this purpose. RAID 6
requires a minimum of 4 disks. RAID 6 can sustain two failed
disks.
RAID 10 has high reliability and high performance. RAID 10 is
implemented as a striped array whose segments are RAID 1
arrays. It has the fault tolerance of RAID 1 and the performance
of RAID 0. RAID 10 requires 4 disks. RAID 10 can sustain two
failed disks.
If the administrator improperly removes a hard disk that should not be removed
when RAID status is Degraded, all data will be lost.
28
Advertisement
Table of Contents
Need help?
Do you have a question about the N5200B PRO and is the answer not in the manual?
Questions and answers