Safety Training Information - Icom ic-m88 Instruction Manua

SAFETY TRAINING INFORMATION

Your Icom radio generates RF electromagnetic energy dur-
ing transmit mode. This radio is designed for and classified
as "Occupational Use Only", meaning it must be used only
during the course of employment by individuals aware of the
hazards, and the ways to minimize such hazards. This radio
W ARN ING
is NOT intended for use by the "General Population" in an
uncontrolled environment.
This radio has been tested and complies with the FCC and IC RF exposure
limits for "Occupational Use Only". In addition, your Icom radio complies with
the following Standards and Guidelines with regard to RF energy and electro-
magnetic energy levels and evaluation of such levels for exposure to humans:
• FCC OET Bulletin 65 Edition 97-01 Supplement C, Evaluating Compli-
ance with FCC Guidelines for Human Exposure to Radio Frequency Elec-
tromagnetic Fields.
• American National Standards Institute (C95.1-1992), IEEE Standard for
Safety Levels with Respect to Human Exposure to Radio Frequency Elec-
tromagnetic Fields, 3 kHz to 300 GHz.
• American National Standards Institute (C95.3-1992), IEEE Recommended
Practice for the Measurement of Potentially Hazardous Electromagnetic
Fields– RF and Microwave.
• The following accessories are authorized for use with this product. Use of
accessories other than those specified may result in RF exposure levels
exceeding the FCC and IC requirements for wireless RF exposure: Belt
Clip (MB-79), Swivel Belt Clip (MB-86), Rechargeable Li-ion Battery Pack
(BP-227), Alkaline Battery Case (BP-226) and Speaker-microphone (HM-
138).
To ensure that your expose to RF electromagnetic en-
ergy is within the FCC and IC allowable limits for occu-
pational use, always adhere to the following guidelines:
C AU TIO N
iii
• DO NOT operate the radio without a proper antenna attached, as this may
damaged the radio and may also cause you to exceed FCC and IC RF ex-
posure limits. A proper antenna is the antenna supplied with this radio by
the manufacturer or antenna specifically authorized by the manufacturer
for use with this radio.
• DO NOT transmit for more than 50% of total radio use time ("50% duty
cycle"). Transmitting more than 50% of the time can cause FCC and
IC RF exposure compliance requirements to be exceeded. The radio is
transmitting when the transmit icon is displayed. You can cause the radio
to transmit by pressing the "PTT" switch.
• ALWAYS keep the antenna at least 2.5 cm (1 inch) away from the body
when transmitting and only use the Icom belt-clips which are listed on
page 35 when attaching the radio to your belt, etc., to ensure FCC and IC
RF exposure compliance requirements are not exceeded. To provide the
recipients of your transmission the best sound quality, hold the antenna at
least 5 cm (2 inches) from your mouth, and slightly off to one side.
The information listed above provides the user with the information needed
to make him or her aware of RF exposure, and what to do to assure that this
radio operates with the FCC and IC RF exposure limits of this radio.
Electromagnetic Interference/Compatibility
During transmissions, your Icom radio generates RF energy that can possibly
cause interference with other devices or systems. To avoid such interference,
turn off the radio in areas where signs are posted to do so. DO NOT operate
the transmitter in areas that are sensitive to electromagnetic radiation such as
hospitals, aircraft, and blasting sites.
Occupational/Controlled Use
The radio transmitter is used in situations in which persons are exposed as
consequence of their employment provided those persons are fully aware of
the potential for exposure and can exercise control over their exposure.