Advertisement
CARF-Models Ltd.
approx.
45 mm
Servo linkages as usual...
Stab/Elevator:
First install the anti rotation pins to
the stab. Drill a 6mm hole into the
fuselage's stab fairing and the stab
rootrib, wax the hole in the fuselage
fairing, stick the 6mm carbon anti
rotation pin into the fuselage and
apply 30 min epoxy on the outer part.
Then slide the stabs on the tube and
over the anti rotation pin, secure with
tape and let the epoxy set. After
sufficient time remove the stab, check
the glue joint of the anti rotation pin
and if necessary, fill the remaining
gaps with glue.
Mill the slots for the hinge posts into
the stab surface's spar. Shorten the
inner hinge post so that it does not
interfere with the stab tube. The
elevators have to be attached to the
Instruction Manual F4U-1D Corsair
info@carf-models.com
Use a couple of 0.8mm ply spacers when
installing the rudder torsion linkage finally.
Drill 6mm, and then WAX the hole
and the surface around!
Page 31
Advertisement
