Reverse Door Swing - Kenmore W10562379A Installation Instructions Manual

REVERSE DOOR SWING

You can change your door swing from a right-side opening to a
left-side opening, if desired.
1. Place a towel or soft cloth on top of dryer or work space to
avoid damaging the surface.
Remove the door assembly
1. Open the dryer door.
2. Remove the bottom screw (B) from each of the two hinges that
attach dryer door to front panel of dryer.
3. Loosen the top screw (A) from each of the two hinges in Step 2.
4. Remove the dryer door and the hinges by lifting upward on the
door. Lay the door on a flat, covered surface, with the inside of
the door facing up. Remove remaining two loose screws from
dryer front panel.
5. Remove the 4 plastic plugs (A) located outside the dryer door
opening.
A
A
A
A
6. Install 4 plastic plugs (A) into screw holes in the dryer left
where the hinges were removed in Step 4.
16
Reverse the strike
1. Remove the door strike from the dryer door opening.
2. Remove the cosmetic screw opposite the door strike.
A
A
B
3. Reinstall the door strike and cosmetic screw on the opposite side
of dryer door opening from where they
were removed.
A
NOTE: Door strike and plugs must be on the same side
B of the dryer door opening.
Reinstall the door
1. Remove the 4 screws and two hinges from the dryer door.
2. Replace the 4 screws in the same holes
3. Remove the 4 screws from the opposite side of the door.
4. Install the two hinges to the door using 4 screws. Use the non-
slotted side to attach the hinge to the door.
A. Door strike
B. Cosmetic screw
B