Reverse Door Swing (Optional) - Kenmore 29" Installation Instructions Manual

REVERSE DOOR SWING
(OPTIONAL)
Super Wide Side-Swing Door
1.
Place towel on dryer
Place towel on top of dryer to avoid damaging the surface.
NOTE: Magnetized screw driver is helpful.
2.
Remove bottom screws
1.
Open dryer door. Remove bottom screws from dryer cabinet side of
hinges. Loosen (do not remove) top screws from dryer cabinet side
of hinges.
3.
Lift door off top screws
Lift door until top screws in dryer cabinet are in large part of hinge
slot. Pull door forward off screws. Set door (handle side up) on top
of dryer. Remove top screws from dryer cabinet.
4.
Remove screws from hinges
Remove screws attaching hinges to door.
5.
Remove screws from door
Remove screws at top, bottom, and side of door (4 screws) that hold
the inner and outer door together. Holding door over towel on dryer,
grasp sides of outer door and lift to separate it from inner door. Set
outer door aside.
NOTE: Do not pry apart with putty knife or screwdriver. Do not pull
on door seal or plastic door catches.
17