Stihl TSA 230 Instruction Manual page 8

English
Use only for charging geometrically
matching STIHL batteries with a
maximum capacity of 50 Ah and a
maximum voltage of 42 V.
Never charge malfunctioning, leaking or
deformed batteries.
Connect the charger only to a power
supply with the voltage and frequency
specified on the rating plate. Always
plug the charger into a properly installed
wall outlet. Do not use an extension cord
unless absolutely neccessary (see
below).
Never use a charger with damaged
housing, damaged power supply cord or
damaged plug. Do not operate the
charger if it has received a sharp blow,
been dropped or otherwise damaged in
any way.
Do not open or dissassemble charger –
there are no user serviceable parts
inside.
Store charger out of the reach of
children.
Protect the charger from
rain and dampness. Keep
charger dry.
Use and store charger
only indoors in dry rooms.
Operate charger at temperatures
between 41 °F (5 °C) and 104 °F
(40 °C).
Allow the charger to cool down normally
– do not cover it.
6
Never bridge the contacts of the charger
with metallic objects (e.g. nails, coins,
jewelry) – which can cause a short
circuit. The charger will be damaged by
a short circuit.
In the event of smoke or fire in the
charger, disconnect it from outlet
immediately.
WARNING
To reduce the risk of electric shock or
short circuit, do not insert any objects
into the charger's cooling slots.
WARNING
The charger heats up during the
charging process. Do not operate on an
easily combustible surface (e.g. paper,
cardboard, textiles) or in an easily
combustible environment – risk of fire.
WARNING
Do not operate in a hazardous location,
i.e. in a location where there are
combustible liquids (fumes), vapors or
dusts. Chargers can produce sparks,
which may ignite the dust or vapors –
risk of explosion.
Check the charger's
power supply cord and
plug regularly for dam-
age. If the power supply
cord or plug is damaged,
immediately disconnect
the plug from the wall
outlet to avoid the risk of
electric shock.
Never jerk the charger's power supply
cord to disconnect it from the wall outlet.
To unplug, grasp the plug, not the cord.
Have a damaged power supply cord or
plug repaired by an experienced
electrician.
Do not use the power supply cord for
any other purpose, e.g. for carrying or
hanging up the charger.
Never use power supply cords that do
not comply with regulations.
Make sure the power supply cord is
located and/or marked so that it will not
be stepped on, tripped over, come in
contact with sharp edges or moving
parts or otherwise be subjected to
damage or stress.
An extension cord should not be used
for your charger unless absolutely
necessary. If an extension cord must be
used, plug the charger into a properly
wired 16 gauge (AWG 16) or heavier
gauge extension cord with blades that
are the same number, size and shapes
as the blades on the charger.
To reduce the risk of electric shock:
Always connect the charger to a
–
properly installed wall outlet.
Make sure the insulation of the
–
power supply cord and plug is in
good condition.
Unplug the power supply cord from the
outlet when charger is not in use.
Never store a battery in the charger.
Abrasive Wheels
WARNING
Before mounting the cutting wheel,
make sure that the maximum operating
wheel speed is above or equal to the
maximum spindle speed of your cut-off
TSA 230