Stihl TSA 230 Instruction Manual page 10

English
diamond wheels are steel centered, and
diamond particles are imbedded in their
cutting edges.
They can be used for concrete, asphalt,
natural stone, clay pipe, brick and the
like. STIHL also offers diamond wheels
for cutting ductile iron and some
structural steel.
They are not, however, suitable for
cutting all metals and other materials.
Wet or dry cutting is possible. Water
attachments are included with your
STIHL cut-off machine. See the
appropriate section of your instruction
manual.
WARNING
Do not remount a used diamond
abrasive wheel without first inspecting
for under-cutting, flatness, core fatigue,
segment damage or loss, signs of
overheating (discoloration) and possible
arbor hole damage. See the chapter
"Diamond Cutting Wheels." Check the
wheel for cracks and make sure that no
pieces have broken off the wheel before
use.
Always fit the wheel so that the arrow on
the wheel points in the direction of the
rotation of the spindle.
THE USE OF THE POWER TOOL
Remove the battery from
the cut-off machine
before:
8
Carrying out tests and adjustments
–
or cleaning work
Fitting or changing the abrasive
–
wheel
Mounting and removing
–
accessories
Leaving the cut-off machine
–
unattended
Transport
–
Storage
–
Performing repairs and
–
maintenance work
This avoids the risk of the motor starting
unintentionally.
Transporting the STIHL Cutquik
WARNING
To reduce the risk of injury from
unintended activation and/or contact
with a moving wheel, always switch off
the machine and move retaining latch to
? when you carry the unit for short
distances. The abrasive wheel
continues to rotate (coast down) for a
short while after the trigger switch is
released (flywheel effect). Bring the
wheel to a stop by lightly contacting the
bottom of the wheel on a hard surface or
wait until the wheel comes to a complete
stop on its own.
When carrying the machine for more
than a few steps, remove the battery
from the cut-off machine.
By hand: When carrying your cut-off
machine by hand, the cut-off machine
must be in the proper position. Grip the
front handle and place the cutting
attachment to the rear.
WARNING
Always protect the cutting wheel from
hitting the ground or any other objects.
Damaged wheels may shatter and
cause serious or fatal injury.
By vehicle: Properly secure your cut-off
machine to prevent turnover and
damage to the cut-off machine. Never
transport with cutting wheel mounted. A
wheel damaged during transportation
may shatter during operation and cause
serious personal injury.
Allow the cut-off machine and battery to
dry out separately if they are wet after
use. During transport, make sure that
the cut-off machine and battery remain
dry. Only transport the battery in clean
and dry containers, do not use metallic
transport containers.
Before Starting
For wheel installation, follow the
procedure described in the appropriate
chapter of your instruction manual.
WARNING
Never operate a cut-off machine if it is
damaged, improperly maintained, or not
completely or securely assembled.
Check machine that it is ready for proper
operation.
Keep the handles dry and clean for a
proper grip.
WARNING
Before operation of your cut-off
machine, be sure the controls (e.g.
trigger switch, trigger switch lockout and
retaining latch) and other safety devices
TSA 230