Removing An Olx Divider; Replacing An Olx Divider - HP 9000 rp4440 Maintenance Manual

Removing and Replacing Components
OLX Dividers

Removing an OLX Divider

To remove an OLX divider, perform the following steps:
An alternative method of removing OLX dividers individually is to remove all OLX dividers at
NOTE
once by removing the rack they are mounted in from the I/O baseboard, then removing or
replacing the individual OLX divider, and then replacing the rack back on the I/O baseboard.
The OLX divider rack is attached to the I/O baseboard with 4 Torx T15 fasteners.
Step 1. If rack mounted, slide the HP Server out from the rack until it stops. (Refer to the hp9000 rp4440
Installation Guide for additional information.)
Step 2. Remove the front bezel. (Refer to "Front Bezel" on page 38.)
Step 3. Remove the top cover. (Refer to "Front and Top Covers" on page 39.)
Step 4. Pull up on the manual retention latch to unlock it from the chassis wall. See Figure 4-29, "OLX
Divider Removal and Replacement."
Step 5. Slide open the latch on the slider gate bracket to unlock the rear edge of the PCI divider. See
Figure 4-30, "OLX Slider Gate Bracket."
Step 6. At this point, if you are removing the entire OLX divider rack, remove the 4 T15 fasteners
attaching the rack to the I/O baseboard.
Step 7. Using your fingers, push the two tabs that attach the OLX divider to the I/O baseboard and pull the
OLX divider up sharply to disengage it from the I/O baseboard.
CAUTION

Replacing an OLX Divider

To replace an OLX divider, perform the following steps:
Step 1. Insert the OLX divider into the available slots on the I/O baseboard and push down firmly to seat it
into the slots.
Step 2. At this point, if you are replacing the entire OLX divider rack on to the I/O baseboard, replace the 4
Torx T15 fasteners.
Step 3. Slide the latch on the slider gate bracket closed, to lock the rear edge of the PCI divider.
Step 4. Push down on the manual retention latch until it locks into the chassis wall.
Step 5. Replace the top cover.
Step 6. Replace the front bezel.
Step 7. If rack mounted, slide the HP Server into the rack until it stops.
84
When extracting the OLX divider, ensure that you release the locking tabs
completely or you may damage them. If you damage the tabs, the OLX divider will
not seat properly when you reinsert it.
Chapter 4