Removing The Display Board; Replacing The Display Board - HP 9000 rp4440 Maintenance Manual

Removing and Replacing Components
Display Board

Removing the Display Board

To remove the display board, perform the following steps:
Step 1. If rack mounted, slide the HP Server out from the rack until it stops. (Refer to the hp9000 rp4440
Installation Guide for additional information.)
Step 2. Remove the front bezel. (Refer to "Front Bezel" on page 38.)
Step 3. Remove the front cover. (Refer to "Front and Top Covers" on page 39.)
Step 4. Using your finger, slightly pull out the retaining tab on the chassis that holds the display board in
position.
Step 5. Gently unplug the midplane riser board connector cable from the display board and remove the
board from the chassis.

Replacing the Display Board

To replace the display board, perform the following steps:
Step 1. Gently plug the midplane riser board cable into the display board.
Step 2. Hold the display board in position near the chassis and rotate it into the retaining clip until it clicks
into place.
Step 3. Replace the front cover.
Step 4. Replace the front bezel.
Step 5. If rack mounted, slide the HP Server into the rack until it stops.
110
Chapter 4