Removing The Quickfind Diagnostic Board; Replacing The Quickfind Diagnostic Board - HP 9000 rp4440 Maintenance Manual

Removing the QuickFind Diagnostic Board

To remove the QuickFind diagnostic board, perform the following steps:
Step 1. If rack mounted, slide the HP Server out from the rack until it stops. (Refer to the hp9000 rp4440
Installation Guide for additional information.)
Step 2. Remove the top cover. (Refer to "Front and Top Covers" on page 39.)
Step 3. Gently squeeze the cover surrounding the QuickFind diagnostic board and remove the cover/board
assembly from the top of the power supply cage.
Step 4. Turn this assembly upside down and remove the QuickFind diagnostic board from the cover.
Step 5. Unplug the cable from the connector on the QuickFind diagnostic board and remove the board from
the chassis.

Replacing the QuickFind Diagnostic Board

To replace the QuickFind diagnostic board, perform the following steps:
Step 1. Gently plug the cable into the QuickFind diagnostic board connector.
Step 2. Replace the QuickFind diagnostic board into the cover by snapping it into place.
Step 3. Turn the assembly over and snap into place on top of the power supply cage.
Step 4. Replace the top cover.
Step 5. If rack mounted, slide the HP Server into the rack until it stops.
Chapter 4
Removing and Replacing Components
QuickFind Diagnostic Board
113