Christie DLV1400-DX User Manual page 89

013-100199-03
Downloaded From projector-manual.com Christie Manuals
Figure 3.16. Match Zones to Center Color Temperature
Repeat the color adjustment of sides and corners for each edge of the screen that does
not yet match the center (note that each corner is adjustable in either of its two
adjacent "side" menus). When done, all areas of a given screen should match. Repeat
Steps & for all remaining screens.
2a 2b
Step 3: Adjust Light Output in Eight Zones
For each screen, compare the light output of each edge and corner to that of the
3a)
center. If any of the areas differ, use the White Uniformity menu to match edges
and corners to the center as described below (see Figure 3.17). Begin with the
screen exhibiting the most obvious variations in light output.
•
Adjust edge White Uniformity first—note that each edge adjustment also
affects the rest of the screen slightly. Keep all edges just slightly lower
than the center light output rather than matching light output precisely.
Otherwise, it may not be possible to brighten the corners (typically the
dimmest areas of the screen) enough. I.e., the best uniformity is a
compromise between the brightest and darkest areas of the screen.
•
Adjust corner White Uniformity last—each corner adjustment affects only
this quadrant.
•
Repeat for each screen.
Figure 3.17. Match Zones to Center Light Output
Step 4: Readjust Color Temperature (level of red/green/blue) in Eight
Zones
Return to Steps
4a) 2a
still exhibit a single color temperature.
& and, if necessary, fine-tune the zones so that they all
2b
Section 3: Operation
3-63.