Christie DLV1400-DX User Manual page 100

Section 4: Maintenance
Power Cord
and Attachments
4-2
Downloaded From projector-manual.com Christie Manuals
•
Do not place the projector on an unstable cart, stand or table. A projector and cart
combination should be used with care. Sudden stops, excessive force and uneven
surfaces may cause the projector and cart combination to overturn.
•
Only use Christie-approved ceiling mount fixture, if the projector is to be ceiling
mounted.
Lamp
Lamp: The projector uses a Cermax® Xenon lamp to deliver its high brightness. A
lamp should be replaced when it has reached its end of life (1000 hrs, typical) or if a
noticeable change in brightness occurs. Keep track of the number of hours the lamp
has been in use (Lamp Menu) and be aware of any changes to brightness. These
indicators will help you effectively maintain operation of the projector.
Wait approximately five minutes after powering down the
projector to allow internal cooling fans to stop and for the
Use only lamps supplied by Christie. Use lamps of the correct
Filter: Replace the filter when you replace the lamp or sooner if required. It is
important the filter be replaced regularly to ensure sufficient airflow through the
projector, otherwise it could cause the projector to overheat.
Refer to 4.4 Lamp and Filter Replacement for instructions.
The North American rated line cord is provided with each projector. Ensure
that you are using a line cord that meets the appropriate rating standards
(CCC for use in China, PSE for use in Japan).
Use only the attachments and/or accessories recommended by CHRISTIE. Use of
others may result in the risk of fire, shock or personal injury.
Use only the AC power cord supplied. Do not attempt operation
if the AC supply is not within the specified voltage and power
•
Do not set or rest items on the power cord. Place the projector in an area where
the projector cord cannot be abused or damaged by persons walking on it or by
objects rolling over it.
WARNING
lamp to cool sufficiently before removing.
Never attempt to remove the lamp housing directly
after use. The lamp is under great pressure when hot
and may explode, causing personal injury and/or
property damage. Allow cooling completely.
WARNING
wattage for your projector model when replacing.
WARNING
Use only filters supplied by Christie.
WARNING
range. Refer to the Specifications in Section 6.
013-100199-03