Christie DLV1400-DX User Manual page 47

013-100199-03
Downloaded From projector-manual.com Christie Manuals
Refer to "Using Slide bars and Other Controls" (earlier in this section) if you need
help using any of the options and controls. Changes made in the Size and Position
menu are applied immediately and are saved when you exit the menu (press
).
Menu
Resize Presets
NOTE: The same resize presets are available to all HD and HD2 widescreen models.
Please note however, the graphics used to describe each preset in this section are of
the SXGA+ models only.
Select a Resize Presets option to
quickly display an image in its
native resolution or to
automatically resize an image to
closely fill the projector's native
resolution or to optimize the
width or height of your display.
Size, Position and Blanking
parameters will automatically
adjust accordingly or, if Blanking
is set first, which defines an Active Input Area; Resize Preset scaling will occur in this
region of interest only. Resizing options are explained in detail below.
WHAT IS THE RESIZING DEFAULT?
image will utilize as much of the projector's display area as possible for the type of
incoming source data, but with minimal or no changes to aspect ratio. See Select
"Default" below.
WHEN "CUSTOM" APPEARS:
the Size and Position menu when any of the values for Size, Vertical Stretch, H-
Position, V-Position or Blanking do not correspond to those for a preset. This option
is not offered in the Resize Presets pull-down list.
• Select
for most sources (factory default). The image will be centered
"DEFAULT"
and displayed as large as possible depending on the type of source.
• Select
to display the image in its native resolution, which may or
"NO RESIZING"
may not match the projector's resolution. For example, for a source with a native
resolution of 800 x 600, "No Resizing" in an SXGA+ projector will use the central
800 x 600 pixels and have a black border—the black border areas are unused areas.
See below.
By default when displaying a new source, your
The "Custom" re-size descriptor automatically appears in
Section 3: Operation
or
Exit
3-21.