Christie DLV1400-DX User Manual page 56

Section 3: Operation
3-30
Downloaded From projector-manual.com Christie Manuals
NOTES: 1) Input levels apply for the current source only, but for any color
temperature used. 2) Assuming that color temperature has been set up based on the
internal test patterns, you can then set up input levels for a given source so that it
matches the color temperature of the internal test patterns.
Temporarily enter a checkmark only if you are an experienced
AUTO INPUT LEVEL –
user and you have an unusual source that you feel needs further color temperature
and/or input level adjustment. This compensates for incoming out-of-range drives
(white) and black levels (black) that would cause "crushing" of light and dark colors
in the image. After entering a checkmark, wait for the six slide bar values to stabilize,
then delete the checkmark and exit. The Auto Input Level is automatically turned off
upon exit from the Input levels Menu.
BLACK LEVELS AND DRIVES -
1. Ensure overall "Contrast" and "Brightness" settings are both set to near 50.
NOTE: Not required for "Auto" adjustment.
•
= 50 (approx.)
Contrast
•
Bright = 50 (approx.)
2. Check the color temperature setup using an internal grayscale test pattern, making
sure to obtain a neutral grayscale. NOTE: Not required for "Auto" adjustment.
3. Confirm that you are using an analog source not connected to INPUT 3 or INPUT
4, as Input Levels are not applicable for digital sources or sources going through
the decoder. A grayscale is recommended.
4. If the blacks and/or whites appear OK, input levels do not need adjustment. If
black levels are too high (and/or whites are too low, which is rare), you likely
have a noisy source that is producing skewed input levels. Continue with Step 5.
5. Temporarily enable "Auto" in the Input Levels submenu. Wait for all 6 values to
stabilize. Alternatively, do not use "Auto"—reduce black levels manually instead.
Judge by eye and change one or more of the six levels as necessary to obtain
proper blacks and whites. You may want to see only a certain color while
adjusting—use the "Color Enable" option (described below).
6. Delete the "Auto" checkmark and leave the Input Levels menu.
IMPORTANT: Do not use Input Levels to adjust color temperature. This will distort
Contrast and Brightness functions as well as color temperature.
When a checkmark is present, selecting a specific black level
AUTO COLOR ENABLE –
or drive to adjust will automatically enable the corresponding color in the display.
Delete the checkmark to see all colors, or to enable a different specific color through
the Color Enable Control.
This option (formerly known as sync tip
CLAMP LOCATION –
clamping) can brighten the image produced from certain high-
resolution high-frequency graphic sources. The projector
automatically selects the best clamp location for almost all
sources. Use the normal Back Porch location if the image is either sufficiently bright or
overly bright. Select Sync Tip if the image appears unusually dim, if there are horizontal
streaks across the image, or if there is significant color drift. This moves the clamping
To check your image levels and adjust these controls:
013-100199-03